Tapewire and Lead-wires
Tapewire, power strips, junction splice, junction splice extender, transformer lead-in wires.
 |
|
 |
|
 |
|
 |
| CK1007 Junction Splice by Cir-Kit |
Price: $4.36
|
| Junction Splice
The CK1007 Junction Splice serves as the juncture point for connecting the lead-in wire to a tape run. The imbedded nails, in addition to holding the connector in place, also establish electrical contact between the tapewire and the male pins on the lead-in wire plug. It is simply placed over the tape run and pounded in. The threaded screw aids in locking the junction splice in place and prevents accidental dislodgement during use. Mates with all CK1008 series of lead in wires. |
|
|
 |
| CK1007-1 Junction Splice Extender by Cir-kit |
Price: $4.96
|
| Junction Splice Extender
If you wish to install your Junction Splice in a less conspicuous location, such as under the dollhouse, use this extender for easy electrical access. Simply plug it into the Junction Splice and run the cord out for mating with the lead-in wire. The extender cord is 18" in length and is equipped with special, insulated wire sockets for connection to the lead wire plug. Instructions included |
|
|
 |
| CK1008 Transformer Lead-In Wire by Cir-Kit |
Price: $5.96
|
| The CK1008 lead-in wire provides a transformer to dollhouse electrical interconnection and may be used with any screw-terminal type transformer. One end of the wire is equipped with a plug for connection to the CK1007 Junction Splice on the dollhouse and the other with spade lugs for connection to the transformer output terminals. Overall length, approximately 6 feet. |
|
|
 |
| CK1008-1 Transformer Lead-In Wire w/switch by Cir-Kit |
Price: $6.96
|
| CK1008-1 Transformer Lead-In Wire with Switch. This lead-in wire may be used for those installations requiring the convenience of total dollhouse on/off power control. (Eliminates need for unplugging lead-in wire from dollhouse to disconnect power.) Same in all other respects as CK1008. |
|
|
 |
| CK1008-2 Transformer Lead-In Wire w/Switch & Fuseholder by Cir-Kit |
Price: $8.96
|
| CK1008-2Transformer Lead-In Wire with Switch and Fuseholder. Same as CK1008-1 but with added in-line fuseholder. Can be used for protection of any transformer with screw terminals. The fuse holder is a threaded assembly and accepts all Cir-Kit fuses. |
|
|
 |
| CK1008-3 Transformer Lead-in Wire w/Switch & Spade Lugs by Cir-Kit |
Price: $9.96
|
| CK1008-3 Transformer Lead-In Wire with Switch and Spade Lugs. Use this lead-in wire in any application requiring spade lugs at both ends, i.e., transformers to terminal blocks. Contains an in-line switch and is identical in all other respects to CK1008-1. |
|
|
 |
|
 |
| HW2217 50foot Conductor Wire by Houseworks |
Price: $6.95
|
| 50 ft. per package. 2 conductor, 32 gauge wire for use in wiring a house with hard wire or when additional wire is required in finishinga dollhouse or miniature project. |
|
|
 |
|
 |
|
 |
|
|
|
